Verify conduction path ‘Path1’

- September 7, 2023 at 10:12 am
  
  Martina Lazzari
  Subscriber
  
  Hi,
  I'm using Maxwell Student 2023 R1 to run a simulation AC Conduction for testing an interaction between blood and two electrodes, but when I enter the dielectric characteristics of blood and I run the simulation, it stop working and shows the following error:
  "Verify conduction path 'Path1': if a conduction path contains current exitation(s), it must contain at least one Voltage or Sink exitation but not both"
  Concerning excitations I'm using two electrodes, one with a current on the lower face and the other one with a sink, always on the lower face.
  How can I check where the problem is?
- September 11, 2023 at 5:59 pm
  
  Reshmi Raghavan
  Ansys Employee
  
  Hello Martina,
  Please check the below points.
  1) Are both the electrodes part of a single conduction path? - check the conduction path
  2) If they are not part of a single conduction path current in and sink has to be defined for both the conductor.