Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Spur gear stress analysis › Reply To: Spur gear stress analysis

September 22, 2022 at 6:15 am
Florian.CHANCEL
Subscriber

Ok, I also understood something thanks to your pictures.

The rotation of your left pinion is counterclockwise => Therefore, after 1.0463 sec, as you can see, you have the last contact point on the last teeth. So there is no anymore teeth to keep the input torque ! I think your calculation fail because of this.

ou cannot have 360° or 10 revolutions because you have only 1/4 of your pinion.

Â