Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to change a SOLID187 into a SOLID185? › Reply To: How to change a SOLID187 into a SOLID185?

July 23, 2021 at 6:42 pm
MickMack
Subscriber

Thanks for the reply
I have added that command to all the solids within my geometry, but it still does not appear to have worked. As you can see the solver is still assigning KEYOPT2(2). 2 images shown below.

I don't see the command snippet in the solver output so i don't believe it is reading it at all. I would expect to see *****Begin Command Snippet* **** in the output file.

I'd appreciate any further suggestions on how to remedy this.

Thanks Michael