Learning Forum

[CMHR]

Hi!

I am currently writing a journal file to extract the cp distribution on an aerofoil. Initially, I created an iso-surface to make a cut plane, than I wrote a command to extract the Cp distribution of that plane/surface. However, this seems to work fine in the command prompt (console) of the GUI but not really in the journal file.

The main reason to this is because i need to press enter whenever there is a selection of zone or surface in the gui but I can not do the same in the journal file. Is there any way to write or tell fluent to press enter?

I have attached some images that might help you understand my jou file and the same thing in the command prompt.

Thank you,

CMHR

Picture of the JOU file:

[CMHR]

Hi!
I found out how to do it, it is just ().
Thanks

[Rob]

() closes a list out. Most of the other commands should automatically trigger the next command.