CP command in specify TIME or STEP on Workbench

- January 26, 2022 at 12:54 pm
  
  j6zoz04
  Subscriber
  
  hi,every one
  Is possible use CP command in specify Time or STEP?
  Take example, in time 1 node1 and node 2 DOF is independent,but in time2 i want to couple their all DOF.
  I try use following command in workbech,but CP command already work in time1.
- January 26, 2022 at 1:13 pm
  
  ErKo
  Ansys Employee
  
  Hi
  Introduce multiple steps, and say step 2 starting from time = 2s.
  In the command snippet we can choose to activate the commands for step 2 (step selection mode and step number=2), which would start from 2s. See here:
  Also the time command is not needed .
  All the best
  
  Erik
- January 27, 2022 at 5:29 am
  
  j6zoz04
  Subscriber
  
  hi @ekostson,thank very much. Your answer is helpful.