Dual potential ECM Li-ion battery model contacts (busbars,tabs) issue

- March 1, 2021 at 5:32 pm
  
  Vincenzodiba
  Subscriber
  
  Hello,
  I'm trying to simulate a simple battery module composed of two cylindrical Li-Ion batteries connected in parallel under a air flow cooling, at 1C rate module discharge for 1200 s. In a first instance, I modelled the positive contacts for both batteries as a single bar (I did the same for the negative one). I performed the simulation assigning these contacts as "tabs" and the simulation converged.
- March 2, 2021 at 12:57 pm
  
  Ashish Khemka
  Forum Moderator
  
  It looks that you have created one more post for the same query and I will mark this one as resolved.
  
  Regards Ashish Khemka