Why are the coordinates I specified and the coordinates outputted in the repor

- May 23, 2024 at 7:32 am
  
  kim kyurae
  Subscriber
  
  I configured the names of the coordinates, the coordinates themselves, and set up the plotting of x, y, z in the Report definition as follows:
  
  However, the results plotted by the plot are different. Why is this happening? I definitely selected 'off' in snap on probe click of the point surface.
- August 6, 2024 at 1:38 pm
  
  Prashanth
  Ansys Employee
  
  I think its area averaging the y coordinate values near the cell where the point is kept. What is the purpose of this point report?