We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. Vof to dpm jet breakup model

Vof to dpm jet breakup model

    • March 3, 2024 at 5:42 pm
      dharanianbu2564
      Subscriber

      Hii,

      I'm doing project on jet breakup model. I'm doing it for unsteady state condition. I have enabled vof and dpm model. And have chosen TAB model and I have used surface injection. K-omega, SBES-WALE model. In results I'm not getting the primary and secondary breakups. Does results should be viewed in tecplot software? Or I can able to view the primary & secondary breakups in post cfd itself. Or is there any mistakes in modelling ? Can anyone please guide me? Thanks in advance.

    • March 4, 2024 at 9:25 am
      Erik Kostson
      Ansys Employee

       

      Hi

      As this is a structural/mechanical forum I would suggest to post your question in the fluids forum as it is fluids/cfd related.

      All the best

      Erik

       

Viewing 1 reply thread
  • The topic ‘Vof to dpm jet breakup model’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.