Vibration separator

- May 3, 2024 at 5:30 am
  
  subin yoon
  Subscriber
  
  We made the following vibration separator in 3D CAD. A specific load will be applied to the upper plate, and the lower plate will be excited at a specific frequency. But I keep getting an error. Please tell me what settings I should start with. We performed modal analysis and then transient analysis.
- May 3, 2024 at 10:52 am
  
  Ashish Khemka
  Forum Moderator
  
  Hi,
  Can you please share the error message? Also, please tell the purpose of this Analysis.
  Regards,
  Ashish Khemka