Unable to add Balloon material
-
-
Hello Guys so I was following a ansys tutorial where it was required to Material Assignment to be set as Balloon but the option is not available for me. Kindly help me regarding this matter. Video Link - Video Link to refer(timestamp - 0:24s)
-
Hello,
Could you open the Engineering Data application from the Workbench by double clicking on it and then verify if the Balloon material is listed there (or only the Structural Steel is defined as shown in the picture below)?
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
You are navigating away from the AIS Discovery experience