We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
LS Dyna

LS Dyna

Topics related to LS-DYNA, Autodyn, Explicit STR and more.

The body does not rotate in LS-Dyna

    • javat33489
      Subscriber

      Hi all.

      A very strange situation. Previously I used a rigid body and set the translation and rotation using RIGID_BODY_MOTION. I made the body deformable and now set the rotation and translation using MOTION_SET. But rotation does not occur. The calculation gives an error, despite the fact that I have specified nodes for rotation

    • Ushnish Basu
      Ansys Employee

      Solid elements typically don't have rotational dofs, so you cannot apply rotations to nodes. To apply rotation to an entire flexible part, use |DOF|=8, 9, 10, or 11.

       

      • javat33489
        Subscriber

        Thanks for the answer. I used these settings. But now the solution is not written down in d3plot and the calculation goes on endlessly, I only see the following lines:

         

        ___

        I used these DOFs

        To make the drill rotate and move downwards

    • Ushnish Basu
      Ansys Employee

      I would need to see the input model to figure out why this is happening, but unfortunately, we cannot provide such specific help in this forum

       

Viewing 2 reply threads
  • The topic ‘The body does not rotate in LS-Dyna’ is closed to new replies.