We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
3D Design

3D Design

Topics related to Ansys Discovery and Ansys SpaceClaim.
  1. All Channels
  2. 3D Design
  3. Sheet Metal

Sheet Metal

TAGGED: ,

    • October 2, 2023 at 1:15 pm
      Roberto
      Subscriber

      Hello

      As an improvement, can it be done that when a sheet metal is developed, the name of the development takes the name of the component?
      This is because if I have more than one sheet metal and I develop them all have the same name and it gets confusing.
      It would be good if it took the name of the component.

      Regards

    • October 2, 2023 at 2:23 pm
      Devendra Badgujar
      Forum Moderator

      Hello Roberto, 

      Closing this, similar to Sheet Metal (ansys.com)

      Regards,

      Devendra 

Viewing 1 reply thread
  • The topic ‘Sheet Metal’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.