Setup not saving

- May 11, 2024 at 12:08 pm
  
  António Oliveira
  Subscriber
  
  Hi,
  I don't know if it's normal, but let's imagine I run a simulation in the setup menu and get the results, then I save the project and close it. The problem is when I open the setup again the results are gone, but the boundary conditions stay the same.
  
  Thanks
- May 14, 2024 at 9:01 am
  
  Rahul
  Ansys Employee
  
  To view the saved results, open it from the solution cell of fluent.