We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. Result set as 0 in ansys mechanical and lift and drag 0 in fluent

Result set as 0 in ansys mechanical and lift and drag 0 in fluent

TAGGED: ,

    • August 7, 2024 at 1:49 pm
      aalvan00
      Subscriber

      Hello, I am working on a project for university involving a 3D wing. When I load the geometry into Fluent and perform the meshing, the lift and drag results only appear in the control volume. Additionally, for that same project in Fluent, the total deformation and the equivalent stress are showing up as 0.

    • August 19, 2024 at 1:51 pm
      Rahul
      Ansys Employee

      Is this an FSI case?

      Could you please share some more details to understand the issue?

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.