Problem with simulation on Ansys Discovery in explore mode

[paolocerre06]

Good evening, I am writing to ask for support in starting simulations on the Ansys Discovery program. When I open the program I can import a geometry and modify it, but I cannot access the "Explore" mode of the program. Inside the notification panel I see an error message: "Graphics device vendor (AMD) is not supported", even though my laptop has a 4 GB Nvidia graphics card in addition to an AMD card. I have already tried to change the GPU used by the program in the Windows settings, but nothing has changed.

[paolocerre06]

[Atharv Joshi]

Hi, 

You can please check if you through the hardware requirements  Ansys Discovery Hardware Requirements (2024 R2) | Ansys Knowledge

Try below settings from Nvidia Control Panel and check if resolves the issue. 

Go to Nvidia Control Panel >> Manage 3D Settings >> Program settings >> Click on Add and select Discovery Program >> Set High performance NVIDIA processor and apply the settings.

Thanks and Regards

Atharv