-
-
February 17, 2022 at 10:40 pm
_1billy
Subscriberhello , i have hard convergence , may anyone suggest me solution
February 18, 2022 at 8:01 amMurari Iyengar
Ansys EmployeeHi _1 billy This issue can occur due to poor mesh quality/incorrect setup. Have you checked mesh quality? Make sure min Orthogonal quality 0.1 and Max Skewness < 0.98. If mesh quality is good, please check the setup to see if you are using the appropriate model and boundary conditions for your simulation.
You can find more information below.
Mesh quality : Check Mesh Quality (ansys.com)
Fluent turbulence models : 13.2. Choosing a Turbulence Model (ansys.com)
Boundary conditions: 7.4. Boundary Conditions (ansys.com)
February 18, 2022 at 3:59 pmAmine Ben Hadj Ali
Ansys EmployeeI do not have crystal ball to know what you have in your case for that reason I stick to the recommendations provided by :)
Viewing 2 reply threads- The topic ‘problem with residuals’ is closed to new replies.
Ansys Innovation SpaceTrending discussionsTop Contributors-
3402
-
1052
-
1051
-
896
-
872
Top Rated Tags© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.
-
The Ansys Learning Forum is a public forum. You are prohibited from providing (i) information that is confidential to You, your employer, or any third party, (ii) Personal Data or individually identifiable health information, (iii) any information that is U.S. Government Classified, Controlled Unclassified Information, International Traffic in Arms Regulators (ITAR) or Export Administration Regulators (EAR) controlled or otherwise have been determined by the United States Government or by a foreign government to require protection against unauthorized disclosure for reasons of national security, or (iv) topics or information restricted by the People's Republic of China data protection and privacy laws.