-
-
September 17, 2024 at 9:07 am
Yohann Biran
SubscriberHello,Â
I have a problem concerning the creation of an array of percages in Spaceclaim. In general, we have the constraint of not being able to position an origin on the center of a percage, but on the other hand, it works well on vertices.
But in the case in PJ, the idea is to be able to place the origin of our percage table on the bottom-left corner of the geometry (see attached image). Normally, this can be done by dragging and dropping, but in this case we can't put it there.Can you help me understand why? I can send you the file.
Best regardsÂ
-
September 19, 2024 at 5:10 am
Devendra Badgujar
Forum ModeratorHello Yohann ,
Let me check and get back to you on this.Â
Regards,
DevendraÂ
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- FSAE CFD – Lesson 1 Preparation question (Using Discovery)
- Script for subtracting models
- Project lines/edges into a face with the direction normal to the face
- Spaceclaim file reference error
- No preview in explorer with scdox file
- Multiple Instances of SpaceClaim taking multiple licenses
- Issues after installing new service pack 2024R1 (sp5)
- Add-in Error Excel
- Problems with loading my Discovery Mesh into Fluent
- Missing SubDivWrapper.dll
Top Contributors
-
3862
-
1414
-
1241
-
1118
-
1015
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.