Probe – x,y,z coordinates

- November 9, 2017 at 7:59 pm
  
  momidor
  Subscriber
  
  Hi,
  
  I wonder how can I obtain x,y,z coordinates of the stress probes which I pointed manually by "Probe" button ?
  
  Thanks in advance
  
  Mom
- November 10, 2017 at 7:12 am
  
  Vishal Ganore
  Ansys Employee
  
  Hi, you can find out the x,y and z coordinates of any node points. By looking at your image, it looks like you are trying to find out the coordinates of points placed in between the nodes which is not possible.
- November 10, 2017 at 7:51 am
  
  momidor
  Subscriber
  
  Hi,
  
  In the past I saw tha table on left dow corner with: probe values and XYZ coordiantes. All this valuse have been appearing simulataneusly always when I was clicking the "probe" button..
- September 12, 2019 at 6:26 pm
  
  ndamle
  Subscriber
  
  Does anyone have an answers to the question reagrding how to get the co-ordinates of the manually created probes in Ansys?
- September 14, 2019 at 12:36 am
  
  peteroznewman
  Subscriber
  
  The Graphics Annotations tab has the X,Y,Z coordinates of Probes.