-
-
September 21, 2023 at 8:15 am
BB1982
SubscriberDear Ansys Support Team
I'm using a conformal mesh created with Advanced Meshing in a CFX case and I realized that the named selection I specified at the interface between two volume zones is the combination of both sides of the conformal interfaces, thus having twice as much area as it should have (checked in Mesh Statistics).
Each individual side of the interface gets assigned a "random" name by the mesher and I'd like to know if there's anything I can do to pass the named selection to only one specific side. Interestingly, the random name is the same for both sides, and it's it's in the format F
. . Thanks and regards
Bruno
-
September 22, 2023 at 1:13 pm
CFD_Friend
Ansys EmployeeHi BB,
May I know why you are interested in passing a named selection to one specific side? Â
Regards
-
September 22, 2023 at 1:19 pm
BB1982
SubscriberHi
I'd like to pass one side only because I need to use that mesh area for a monitor point and in an automated post processing script.
Regards
Bruno
-
- The topic ‘naming of conformal interfaces in CFX’ is closed to new replies.
-
2778
-
965
-
841
-
599
-
591
© 2025 Copyright ANSYS, Inc. All rights reserved.