Meshing fluid domain
-
-
I am creating a fluid domain to run a droplet simulation. The domain is rectangular, with the bottom surface having rectagular shaped channels:
Â
The general idea is to run droplet simulations where I alter the dimensions of these channels to analyze how it affects droplet dynamics. When I mesh the domain, I get a relatively uniform hex mesh using the multizone method and adjusting mesh sizing:
While this method works overall, ideally I would like to create a more uniform mesh, particularly fixing the meshing on the top/bottom surfaces as they look like this:
Â
Any thoughts on how this could be done?
-
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
You are navigating away from the AIS Discovery experience
