TAGGED: -Force-calculation, data, moment-calculation, unsteady-flow
-
-
October 6, 2024 at 5:13 pm
sobol.ofiszal
SubscriberHi,
I've encountered a problem regarding a access to a mean force and moment data sampled via the Data Sampling for Time Statistics feature. Is it possible to access this data either via a file or directly in fluent in the same way as instantaneous values of force and moment can be access via report tab or a .out file? The only way to access that I've found was via a cummulative plot tab, but I wonder where could I access this data in a way similar to one mentioned earlier.
Best regards
-
October 7, 2024 at 12:00 pm
Rob
Forum ModeratorDon't think so. If you monitor the value(s) you can work out the average outside of Fluent.
-
October 8, 2024 at 9:20 am
sobol.ofiszal
SubscriberThank you very much. Just wondered if Fluent is collecting this data already, I could access it somehow.
-
- You must be logged in to reply to this topic.
- air flow in and out of computer case
- Varying Bond model parameters to mimic soil particle cohesion/stiction
- Eroded Mass due to Erosion of Soil Particles by Fluids
- Guidance needed for Conjugate Heat Transfer Analysis for a 3s3p Li-ion Battery
- I am doing a corona simulation. But particles are not spreading.
- Issue to compile a UDF in ANSYS Fluent
- Centrifugal Fan Analysis for Determination of Characteristic Curve
- JACOBI Convergence Issue in ANSYS AQWA
- affinity not set
- Resuming SAG Mill Simulation with New Particle Batch in Rocky
-
3862
-
1414
-
1236
-
1118
-
1015
© 2025 Copyright ANSYS, Inc. All rights reserved.