-
-
December 4, 2023 at 9:44 am
jaafar.elwati
SubscriberHello everyone, I hope you are doing very well.
I'm working on a PMSM machine simulation to calculate the magnets losses. The problem is that I'm getting high magnets losses value and the efficiency is around 86%.
Is there any suggestions to increase the efficiency?Â
-
December 4, 2023 at 1:20 pm
NKC
Forum ModeratorHi Jaafar,
Reducing Magnetic losses in a machine is a design decision. Ansys employees cannot help users with any design or project-related information.Â
You can look at various factors in the electrical machine that are responsible for high core loss. such as the core loss of the steels you have considered at the operating frequency, the thickness of the lamination e.t.c.,
We encourage other users in the forum to pitch in for further discussion.
We are happy to help you if you have any issues with Ansys tools.
Regards,
Navya
-
- The topic ‘Magnets Loss simulation’ is closed to new replies.
- Y wiring method and the start and end points of winding.
- Lumped Port Deembed
- Optimizing Via Impedance in Ansys HFSS 3D Layout Using Geometric Parameter Sweep
- Hfss 3D pcb via capped and filled with epoxy
- AEDT Natural Convection with default correlation is failing solver initializatio
- HFSS libnvidia-ml.so too old or could not be found – Warning in slurm job output
- Three-Phase Voltage Imbalances in dual stator electric generator
- STL Import Errors in HFSS After Cleaning in SpaceClaim
- Calc Error in Field Calculator after PyAEDT Analyze
- import file autocad 3d
-
3882
-
1414
-
1241
-
1118
-
1015
© 2025 Copyright ANSYS, Inc. All rights reserved.