Linking Simplor to Maxwell ACT Transformer Project
-
-
I have developed two models in ANSYS Electronics Desktop, a transient circuit transient in Simplorer and a Planar Transformer design that I used the ACT Electronic Transformer Extension to make the 3D Maxwell magnetostatic model.
I would like to link the Maxwell model into Simplorer and run a transient simulation using the model of the actual transformer, rather than an approximation. Additionally I would like to use the linked Simplorer/Maxwell model to see heat loss in the transformer. I know this can be done in Ansys and have seen screenshots from training seminars showing this process, but if you could provide a step by step setup that would be great. Thank you!
Viewing 1 reply thread- The topic ‘Linking Simplor to Maxwell ACT Transformer Project’ is closed to new replies.
-
You are navigating away from the AIS Discovery experience
