Iso-surface movement during SLM simulation in ANSYS

- July 4, 2024 at 1:50 am
  
  mercypham
  Subscriber
  
  Dear all,
  
  I am dealing with SLM process, I get problem that when the laser irradiate on the powder, the iso-surface moves up as I shown in the figure. Does anyone have any advices to solve this problem?
  
  Thank you all.
- July 4, 2024 at 9:17 am
  
  Rob
  Forum Moderator
  
  I'm being fairly lenient with multiposting due to Forum gremlins, but as I've cleared up several of the above posts that may change.