Learning Forum

[sicli21]

Hi I have the model below. When I run simulation it is not always giving me correct results. The  gain graph looks like below for the same simulation. Sometimes it gives green results, sometimes it is the blue one. I tried to change max no of iterations and stop on convergence setting  of ONA but no improvement achieved. 

 

 

[Dev]

Hello,

Thanks for using forum. Aplogies for the delay in response. 

Please show a clear full image of the result. Seems like the Y axis scale is 0. 

This could happen if the element parameters are wrong.

Thanks and regards

Devika

 

[sicli21]

Hi, I uploaded another image. Parameters cannot be wrong because when I re-run my simulation I get expected results. But it can be several reruns to get the result. I observe this effect whenever I use OMM. In the image below blue and green are from same simulation but different runs.