Learning Forum

[ksoltyk]

Hello Ansys Community,

I am currently working on a simulation project involving a climbing rope, and I'm seeking advice on material selection and simulation parameters.

The climbing rope exhibits anisotropic properties rather than isotropic ones, and I wonder if anyone has experience in designing such ropes. Specifically, I am interested in understanding whether assigning properties in different directions is sufficient to accurately simulate the behavior of the rope in the device.

My focus during the simulation is primarily on the device itself, not just the rope. I aim to model the rope as a single entity with the appropriate characteristics, such as low transverse stiffness and good flexibility. The rope will experience frictional contact and needs to slide smoothly within the device.

Has anyone previously worked on a similar project or can provide guidance on the parameters and values that would be suitable for an accurate simulation? I am particularly interested in recommendations for achieving the desired behavior, considering the anisotropic nature of the climbing rope.

Any advice, suggestions, or shared experiences would be greatly appreciated. Thank you in advance for your time and assistance.

[Ashish Khemka]

Hi,

Please try doing a web search for a research article on 'Design and analysis of elevator wire ropes'. I am not sure but it may be useful

Regards,

Ashish Khemka