Induction Core Temperature not rising

- February 21, 2023 at 6:32 pm
  
  Asif Haq
  Subscriber
  
  Hello.
  I am doing a induction coil and core heating simulation using a single coil. I have set the follwoing settings in maxwell
  Solver Setting - Eddy
  Eddy Effect - Core
  Customised bulk density for the core
  Transient Solver Setting
  Convection
  Load Imported from Maxwell
  Requirement
  Temperature
  
  This is the result i am getting. I tried increasing the time but it only increased by 1 degree. I am not sure what more to do here.
- February 22, 2023 at 5:29 pm
  
  Asif Haq
  Subscriber
  
  My expectation is to see the temperature rise upto 1000 degrees. I am not sure what is wrong here.
- February 22, 2023 at 5:31 pm
  
  Asif Haq
  Subscriber
  
  Project File
  I have set uploaded the file in the link above. If any one watns to check.
- February 27, 2023 at 11:26 am
  
  Ashish Khemka
  Forum Moderator
  
  Hi Asif,
  
  What is the time taken for the temperature to 1000 degrees? Currently, it looks like the analysis is solved for 1 second.
  
  Regards,
  Ashish Khemka
  - February 27, 2023 at 1:19 pm
    
    Asif Haq
    Subscriber
    
    I put in 20000 seconds as step end time. But stil does not reach
  - February 28, 2023 at 4:25 pm
    
    Asif Haq
    Subscriber
    
    I put the following settings and now i am getting results. the temperature is going higher then expected
  - February 28, 2023 at 4:28 pm
    
    Asif Haq
    Subscriber
    
    I know the scaling factor should be as close as possible to 1. How do i get around this.