ICEM error when converting pre-mesh to unstruct mesh

- November 29, 2017 at 7:24 pm
  
  jianan.zhao
  Subscriber
  
  After generating structure mesh, when I try to convert pre-mesh to unstruct mesh, error occurs as shown in the picture. Can anyone help explain what might be the reason causing this problem? Thanks!
  
  -Jianan
- November 29, 2017 at 11:02 pm
  
  raul.raghav
  Subscriber
  
  As the pre-mesh to unstruct mesh is complete, ICEM-CFD should load a ".uns" mesh file. For some reason it is not able to locate the ".uns" mesh file. Does your ICEM-CFD have admin rights to write files in your working folder? If I were in your shoes, I'd try
  
  1. Saving the ICEM project in a different folder and trying this process again, or
  
  2. Run ICEM as administrator and see if that would fix the issue.
  
  Good luck!
- November 29, 2017 at 11:14 pm
  
  jianan.zhao
  Subscriber
  
  Thank you Rahul for your help! It workes after I save the ICEM project in a different folder. I was trying to change the working directory, which did not make a difference. Thank you again for your help -- Jianan