We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.

I am getting the error: ‘One or more faces with map mesh controls failed to be m

TAGGED: 

    • Ffatihkaraoglu
      Subscriber

      Hello everyone, I am new to using ANSYS. When I try to complete this simulation without interruption by following ANSYS's own course, I encounter this error. Is there a simple way to fix this? (https://innovationspace.ansys.com/courses/courses/cardiovascular-stent/lessons/geometry-lesson-3-4/) Additionally, are there any courses for medical simulations like these in ANSYS that can help me improve and learn the program better? I really want to develop myself in this area. Thank you very much in advance.

    • peteroznewman
      Subscriber

      Hello Faith, 

      The message is a warning.  It may not have been triggered on the older version of Ansys the course was recorded in. You should be able to proceed with the simulation by suppressing Face Meshing. I have some experience with stent expansion simulations if you need more help.

      Regards,

      Peter

      • Ffatihkaraoglu
        Subscriber

        Thank you for the answer.

Viewing 1 reply thread
  • The topic ‘I am getting the error: ‘One or more faces with map mesh controls failed to be m’ is closed to new replies.