Learning Forum

[Dato]

Hi,

I'm going to do a contaminant migration simulaiton in ocean. Now I found geospatial coordinate data in MATLAB and ploted three-dimension image in MATLAB.  I exported the image as .stl file and imported it into SpaceClaim. But it becomes facets rather than a body as shown below. 

The image at left is axial position and right one is top view. Facets is shown in structural tree. From my viewpoint, I think the reason may be like that: .stl file exported from MATLAB is merely spatial coordinate and when imported into CAD software it automatically link the points and form intersected surfaces. 

I have tried to repair Facets in Facets and Repair panel but nothing worked.

Any suggestions would be highly appreciated!

 

[Devendra Badgujar]

Hi Lee, 

You can refer this Discovery SpaceClaim: Reverse Engineering - Ansys Knowledge for repairing these facets.

Regards,

Devendra