Learning Forum

[SaurabhDas]

Hi..

I had one of my doubts cleared as to how I could control the meshing charateristics of the two different meshes I made. 

This:

turned to this:by using 'Shared topology' (More at this link: /forum/forums/topic/mesh-control-in-the-following-figure/

However, after using shared topology, both component became one part, and in fluent, this is what it looks like..

These are the mesh components:

How do I separate the interior and exterior zone to apply boundary conditions on them and obtain results? Thank you..

[Keyur Kanade]

go to mesh

select interior body.

right click and create named selection. 

create named selection for body. this will come in fluent.