We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. Hotspot shifts after slicing for sweep mesh

Hotspot shifts after slicing for sweep mesh

TAGGED: ,

    • August 27, 2024 at 10:45 am
      Subash Niraula
      Subscriber

      Hello everyone, 

      I am new to ansys and I am doing a static structural analysis for a worm part of worm gear assembly. After I found hotspots in keyway, I sliced for sweep meshing and now solving for equivalent stress results in new hotsposts. Could anybody please explain why and how to solve this problem? Thank you in advance.

    • August 27, 2024 at 12:34 pm
      Ashish Khemka
      Forum Moderator

      Hello,

      Please see if the following link helps.

      Regards,

      Ashish Khemka

    • August 27, 2024 at 7:44 pm
      Subash Niraula
      Subscriber

      Hello Ashish,

      the link is not showing in your reply. Could you please post it again. Thanks.

      Regards

      subash

    • August 28, 2024 at 1:07 pm
      Ashish Khemka
      Forum Moderator

      Hi,

      My apologies!

      Following is the link: innovationspace.ansys.com/courses/courses/tips-and-tricks-for-structural-simulation-in-ansys-mechanical/lessons/assessing-stress-singularity/

      Regards,

      Ashish Khemka

Viewing 3 reply threads
  • You must be logged in to reply to this topic.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.