HFSS Hybrid: Simulation error

- October 23, 2018 at 5:12 pm
  
  mahmoud
  Subscriber
  
  Hi,
  
  I am trying to simulate an FSS on a dielectric reflector (both of them mimic a radome) and use Hybrid HFSS setup. What I did is to assign both the FSS surface and the dielectric reflector as a IE region. Then enclose them in a FEBI open box.
  
  I tried to simulate, but I get this error below, which I do not know how to overcome it. Also, the way I drew the FSS on top of the dielectric reflector is to imprint it.
  
  Any help is appreciated.
  
  Thanks,
  Mahmoud
- October 23, 2018 at 5:13 pm
  
  mahmoud
  Subscriber
  
  One more note: the FSS is a sheet and the reflector has a thickness