Get zero value (blue colour) after run successfully
-
-
Hi, I have this problem where after running the simulation in the 2D model, I got zero value (blue colour) meanwhile in the colour distribution result table I've got until the highest value red colour (0.3155 A/m). I used Ansys maxwell magnetic transient solution type.
My question is the blue colour I assign is air but I'm not satisfied with the colour results on the model in order to find the current induced based on colour. I'm not sure which part I should overcome.
I have already tried increasing the mesh value but still the same. Does everyone have this problem and how to overcome it?
-
Viewing 0 reply threads
- The topic ‘Get zero value (blue colour) after run successfully’ is closed to new replies.
You are navigating away from the AIS Discovery experience
