TAGGED: beam-elements
- 
		
			- 
October 20, 2023 at 11:15 pm
- 
October 21, 2023 at 8:38 pmSampat Kumar Ansys EmployeeHi Mehndi, 
 I think your question is not uploded correctly. Please post your question again.Â
 Regards,
 Sampat- 
October 21, 2023 at 11:24 pmMehdi Baghaee SubscriberCorrected! 
 
- 
- 
October 23, 2023 at 10:17 pmMehdi Baghaee Subscriber Any comment?! It seems the section offset does not work is this case! 
 
- 
Viewing 2 reply threads
	
- The topic ‘How to model a stepped beam in general form using only beam elements in APDL?’ is closed to new replies.
                Innovation Space
                 
            
            
            Trending discussions
             
        
        - LPBF Simulation of dissimilar materials in ANSYS mechanical (Thermal Transient)
- Convergence error in modal analysis
- APDL, memory, solid
- Meaning of the error
- How to model a bimodular material in Mechanical
- Simulate a fan on the end of shaft
- Real Life Example of a non-symmetric eigenvalue problem
- Nonlinear load cases combinations
- How can the results of Pressures and Motions for all elements be obtained?
- Contact stiffness too big
            Top Contributors
             
        
        - 
                        
                        4167
- 
                        
                        1487
- 
                        
                        1358
- 
                        
                        1189
- 
                        
                        1021
            Top Rated Tags
             
        
        
    © 2025 Copyright ANSYS, Inc. All rights reserved.
            Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.
        
    
 You are navigating away from the AIS Discovery experience
You are navigating away from the AIS Discovery experience 
               
          