Learning Forum

[Átyla Matheus]

Good afternoon, I would like to know if anyone could help me put this information into fluent. I've already done the geometry and mesh part, but I'm not able to include this information that I took from an article. I don't know if I'm missing some information or if I really don't have command of some of the program's tools. I'm looking to validate my work based on this article I found and to do that I need to be able to set these properties.
- Mixing model with 4 phases.
- How to set fresh water, cuttings, gas and formation fluid?
- How to use this information about 100.00 ppm brine?
- How to set the forming temperature to 100°F?

Attached are photos of my geometry and my mesh, as well as the cut prints of the article in question on which I am basing it.

[SRP]

Hi,

Which multi phase model you are using to run the simulation?

[Átyla Matheus]

I haven't used any yet. But the article I'm basing it on uses the mixture model.