We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
Ansys Products

Ansys Products

Discuss installation & licensing of our Ansys Teaching and Research products.
  1. All Channels
  2. Ansys Products
  3. Fail to launch CFD-POST on LINUX

Fail to launch CFD-POST on LINUX

TAGGED: , , , ,

    • August 1, 2024 at 10:27 pm
      yu272
      Subscriber

      Hi,

      I recently encountered an issue launching CFD-Post from Workbench, which is on a virtual desktop on University cluster. This happens after a system upgrade for the cluster.

      Below is the error message from Workbench:

      Here is the error message in terminal (I launched Workbench from terminal, and everything else works fine.)

      Thank you!

      Eric

    • August 7, 2024 at 2:12 pm
      George Karnos
      Ansys Employee

      Hello Eric,

      Try verifying that hardware acelleration is enabled.

      • August 15, 2024 at 6:10 pm
        yu272
        Subscriber

        Hi George,

        Sorry for the late notice. I tried and the same error still pops. Do you have any other suggestions? 

        Sincerely,

        Eric

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.