TAGGED: ansys, errors, fluent, Mesh-Ansys-Fluent
-
-
October 31, 2021 at 2:29 pm
Sreehari_33
SubscriberHi, I'm new to fluent and was trying to simulate a cell using the battery model add-on module, but I keep getting these errors when pressing ok after entering the cell specs. Please help.
"Error: wta(2nd) to string_append
Error Object: #f"
thank you in advance
November 1, 2021 at 12:29 pmKarthik Remella
AdministratorHello Could you please add a screenshot illustrating the steps you are performing so we understand the issue better? Please post your screenshot directly in your reply (not as an attachment). Is this Fluent or Fluent meshing?
Karthik
Viewing 1 reply thread- The topic ‘error:wta(2nd) to string_append’ is closed to new replies.
Ansys Innovation SpaceTrending discussions- air flow in and out of computer case
- Varying Bond model parameters to mimic soil particle cohesion/stiction
- Eroded Mass due to Erosion of Soil Particles by Fluids
- Centrifugal Fan Analysis for Determination of Characteristic Curve
- Guidance needed for Conjugate Heat Transfer Analysis for a 3s3p Li-ion Battery
- I am doing a corona simulation. But particles are not spreading.
- Issue to compile a UDF in ANSYS Fluent
- JACOBI Convergence Issue in ANSYS AQWA
- affinity not set
- Resuming SAG Mill Simulation with New Particle Batch in Rocky
Top Contributors-
3892
-
1414
-
1256
-
1118
-
1015
Top Rated Tags© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.
-