Error message while meshing: ‘mesh has uncovered edges’…?

- March 5, 2023 at 10:58 am
  
  Naresh
  Subscriber
  
  Hi, I've been trying to save my ICEM mesh but when I try to, it says this:
  'Mesh has uncovered edges. Ansys fluent needs a complete boundary (lines in 2D) or it will give a variety of errors and not read in the mesh! If this was 2D hexa, perhaps your edges are not associated with perimeter curve'.
  
  what does this mean please?
- March 6, 2023 at 4:38 am
  
  Keyur Kanade
  Ansys Employee
  
  You can check and fix blocking. Please use 'Check Bocks' under blocking.
  Please go through help manual for more details
  Regards,
  Keyur
  How to access Ansys Online Help Document
  Guidelines on the Student Community
  Fluids Engineering Courses | Ansys Innovation Courses
- March 11, 2023 at 2:56 pm
  
  Naresh
  Subscriber
  
  Hi, I tried the block checks, and it still shows the same error message when I try output the mesh?
  
  any other suggestions please?
- March 13, 2023 at 6:15 am
  
  Keyur Kanade
  Ansys Employee
  
  You need to fix the blocking.
  Please go through help manual for more details
  Regards,
  Keyur
  How to access Ansys Online Help Document
  Guidelines on the Student Community
  Fluids Engineering Courses | Ansys Innovation Courses
  - December 20, 2023 at 9:23 am
    
    Majid Panahi
    Subscriber
    
    Hello
    Dear Keyur
    I have the same problem, But when that selected the above link, that no found in results