[error] Error in mesh mapping on band, please check the potential problem in band setting.

- August 25, 2021 at 6:24 am
  
  Kashish
  Subscriber
  
  I am using a polyhedron band for simulation of an outer rotor motor. The sides of the polyhedron are 12 both inner and outer.
- August 25, 2021 at 10:14 am
  
  Navya Chode
  Forum Moderator
  
  Hi @Kashish Please use more segments for the polyhedron, say 120 or more
  
  Regards Navya
- August 25, 2021 at 2:20 pm
  
  Kashish
  Subscriber
  
  I started from 120 segments all the way to 150 but it keeps giving the same error
  
  Regards Kashish
- September 1, 2021 at 2:55 pm
  
  DELI
  Ansys Employee
  
  you need an inner band inside the band, please refer this thread:
  /forum/discussion/comment/124468#Comment_124468
- September 1, 2021 at 5:01 pm
  
  Kashish
  Subscriber
  
  I get an error of overlapping bands but they are not even touching each other.
  The highlighted is the inner band you asked to make. I have put it completely in the outer band as you can see it is not even touching the edges of the outer band.
- March 14, 2022 at 7:38 am
  
  Mc145921
  Subscriber
  
  hi @Kashish´╝îIs this problem solved, I have the same error
- March 14, 2022 at 7:52 am
  
  Kashish
  Subscriber
  
  No. It hasn't.
- March 14, 2022 at 1:02 pm
  
  Mc145921
  Subscriber
  
  I've tried the same models, some work, but most don't, I don't know why