We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Innovation Space

FREE STUDENT SOFTWARE

Error ansys motorcad when using certain dimensions

- March 19, 2021 at 5:57 pm
  
  Noah2021
  Subscriber
  
  I am collecting data for a mathematical model for an IPM motor.
- March 24, 2021 at 2:57 pm
  
  HDLI
  Ansys Employee
  
  Hello Noah2021,n The MotorCAD could not run if the geometry has an issue. From the enclosed picture, I find there may be a conflict in rotor geometry.n I suggest to check the critical geometry like min. stator ID and max. air gap. and verify the geometry that we can use to build the model for all the variations. Thanks.nnBest regardsnn n n

Viewing 1 reply thread

The topic ‘Error ansys motorcad when using certain dimensions’ is closed to new replies.