*** Error 40058 (SOL+58) retractor 1000002:convergence failure at time1.01E+02

- August 29, 2024 at 10:58 am
  
  Abraham Thomas Chirathalattu
  Subscriber
  
  Hi,
  I am trying to run a crash simulation and the above error termination occurs. It says retractor convergence failure at time 101.3ms. I am using LS-DYNA R13 double precision solver to run the job. Can anyone please help resolve the issue? the following are the restractor parameters used:
  TDEL: 0.5
  PULL: 5.0
  LFED: 12.0
  loading and unloading curves are defined and are based on coupon tests conducted.
- September 3, 2024 at 2:32 pm
  
  Ram Gopisetti
  Ansys Employee
  
  Hi Abraham,
  This error can be triggered if the material type and/or load curve used in pull-in and pull-out for retractor may have a problem. Please check and make sure there is no unrealistic values set.
  Cheers,Ram
- December 7, 2024 at 11:28 am
  
  99993959
  Subscriber
  
  HI,Abraham,
  Can you reslove it?I have a similar question:
  *** Error 40057 (SOL+57) slipring 1000024:convergence failure at time1.01E+02
  but I can't find the slipring 1000024 in my model.