We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. error

error

    • April 23, 2020 at 6:41 pm
      sreeraj98
      Subscriber

    • April 23, 2020 at 6:42 pm
      sreeraj98
      Subscriber

      what can i do to resolve the error ? kindly guide me through this 

    • April 24, 2020 at 2:03 pm
      peteroznewman
      Subscriber

      I haven't looked at your model, but the error is "unable to converge".


      Here is a Google Search on that phrase on this site which has 217 results.


      Read most of those posts and try a few of the suggestions. Come back with a specific question.

    • May 1, 2020 at 5:47 am
      sreeraj98
      Subscriber
      Hey Peter Can u have a look at the model and advise me if there is any problem like penetration or gap...
      After reading that article I found that my geometry is not so complex and the main error is it cant converge to a solution and substep 9999 error.
      It would be helpful if u could advise me with the geometry it's a geneva mechanism.
Viewing 3 reply threads
  • The topic ‘error’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.