domain Interface issue

- August 9, 2018 at 3:37 pm
  
  HZhang
  Subscriber
  
  We have run into an issue with domain interface for a stirred tank. The velocity profile is attached. It is not correct to have an interface boundary for the velocity profile. We have created three interfaces for the top, bottom and side boundaries of the inner zones, setting up the interface wall for the inner zone is moving wall but relative to the zone with a zero speed. Any comments?
- August 9, 2018 at 8:40 pm
  
  Raef.Kobeissi
  Subscriber
  
  Hi,
  
  Can you explain what you mean by this:
  
  It is not correct to have an interface boundary for the velocity profile.
  
  Can you upload the case to properly understand the setup.
  
  Thank you