Learning Forum

[smjang]

Hi,
I have a question about Discovery.

The first is to set the concentrated load and equivalent distributed load.
When performing structural analysis, there are Force and Pressure. I wonder if it is possible to set the concentrated load and the equivalent distributed load using these two functions.

The second is to check the safety factor.

I checked it in Discovery, but I can't confirm if I'm not finding it properly.

Thank you. 

[smjang]

When I checked again, I confirmed that the safety factor can be checked on the monitor chart in the upper right.

[Subashni Ravichandran]

Hello smjang

The Force boundary condition in Discovery applies a Uniformly(equivalent) Distributed Load. There is currently no option to set a Point (Concentrated) load in Discovery.

Is this what you are looking for? I hope I have clarified your query.

[smjang]

Subashni Thank you. You answered my questions.