diesel spray

- September 21, 2022 at 5:21 pm
  
  Andrea Paniccia
  Subscriber
  
  what is the correct way to inject a specified cone angle?
  currently I am simulating the 2D case, in steady state.I should simulate a nozzle located at the origin of the axes, i know nozzle's diameter. I am using 'plain orifice atomizer' as the injection system, but I get an injection system like the one shown in the figure. is that correct?
- September 22, 2022 at 10:20 am
  
  Rob
  Forum Moderator
  
  I didn't think the atomiser models were available in 2d: they're designed for 3d domains.