We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. crush capacity analysis

crush capacity analysis

TAGGED: 
    • February 20, 2025 at 11:01 am
      raegab
      Subscriber

      Hi, I am conducting a crush capacity analysis of an umbilical using static structural analysis. I am using two pads to crush the umbilical, but when I run the simulation, all the forces seem to concentrate in a small area rather than being evenly distributed across the umbilical. Are there any known reasons for this?

    • February 20, 2025 at 2:26 pm
      Armin
      Ansys Employee

      Hi Raegab,

      Could you include a picture at the start of the analysis before deformation begins? From the picture you sent, it appears to me that the mesh is severely distorted in a local area. For this type of application you may look into explicit dynamics solver like Autodyn or LS-DYNA.

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
Ansys Innovation Space
Top Contributors

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.