We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.
  1. All Channels
  2. General Mechanical
  3. Crack growth error

Crack growth error

    • March 12, 2024 at 1:23 am
      Tasuku Ito
      Subscriber
      A semi-elliptical crack is inserted into the inner wall of a circular pipe, and a load is applied in the opposite direction to the direction of crack growth. And the result of this is always not parsed to the end and stops midway. In addition, the crack growth suddenly becomes linear from the middle. Please let me know the cause of such an error.
    • March 19, 2024 at 2:31 am
      Ashish Khemka
      Forum Moderator

      Hi,

      It would be difficult to comment without looking into the model and Ansys employees cannot help you with the same on forum. Please wait for other members o repond. In case you have access to Ansys Technical support then you can raise a case over there.

       

      Regards,

      Ashish Khemka

Viewing 1 reply thread
  • The topic ‘Crack growth error’ is closed to new replies.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.