TAGGED: crack-analysis, crack-growth, paris-law
-
-
June 5, 2024 at 12:01 pmfeto69Subscriber
***Error
***
NUMBER OF PARAMETERS 4 FOR CGCR TABLE FOR MATERIAL 1 CANNOT EXCEED 2
Hello everyone,
I am currently working on a project in Ansys Workbench where I aim to initiate a smart crack in a piece of reinforced concrete using the Paris law, rather than by static stress initiation. However, I keep encountering the following error (please specify the error message if you have it).
Could anyone provide assistance or guidance on how to correctly set up the simulation to achieve this?
Thank you very much for your help!
-
July 4, 2024 at 2:34 pmAshish KhemkaForum Moderator
Hi,
It seems that you have asked the same query here:Crack growth analysis Paris Law Constants (ansys.com)
I will close this thread.
Regards,
Ashish Khemka
-
- The topic ‘Crack growth analysis’ is closed to new replies.
- Ayuda con Error: “Unable to access the source: EngineeringData”
- At least one body has been found to have only 1 element in at least 2 directions
- Error when opening saved Workbench project
- How to apply Compression-only Support?
- Geometric stiffness matrix for solid elements
- How to select the interface delamination surface of a laminate?
- Timestep range set for animation export
- Image to file in Mechanical is bugged and does not show text
- SMART crack under fatigue conditions, different crack sizes can’t growth
- Frictional No separation contact
-
1296
-
591
-
544
-
524
-
366
© 2025 Copyright ANSYS, Inc. All rights reserved.