General Mechanical

General Mechanical

Topics related to Mechanical Enterprise, Motion, Additive Print and more.

Contour error on Static structural analysis

    • Joshua James
      Subscriber

      Hi, looking for help on attached error message, my simulation is a crack on pipe structure under load

    • Erik Kostson
      Ansys Employee

      Hi

      This post explains this:

      /forum/forums/topic/fracture-contour-end/

      All the best

      Erik

    • Joshua James
      Subscriber

      Hi Erik, thanks for the reply, however I was not able solve with the post that you have linked. Is there a specific step i should take to adjust the contour setting, any help is appreciated. Below is the error message pop up.

Viewing 2 reply threads
  • The topic ‘Contour error on Static structural analysis’ is closed to new replies.